Usage Of Dough Mixer Commercial Bread Dough Mixer

Before the mixer, Firstly, check the model, rated output, frequency, phase number, voltage and agitation of the mixer on the nameplate to meet the required specifications. Then confirm whether the product is damaged during transportation. In particular, it is necessary to pay attention to whether the appearance of the cable wire causes the copper wire to be exposed and whether the screw or the nut is loose. Finally, confirm that the number of attachments is complete.

Please note that the mixer must run clockwise before installation.(look from top to bottom, turn right).
When you use a blender, you need a power supply of the right amount. If a small-capacity power supply is used, it may cause clearing that cannot be started.Please pay attention to the power supply capacity. Please confirm that the frequency and voltage you use are the same as those stated on the nameplate. (In particular, when the engine is powered, it is necessary to pay attention to changes in frequency and voltage).

The voltage is used within ±10% of the allowable value of the rated voltage variation of the mixer. When moving the machine, you must not pull the cable to avoid the cable from rupturing and the leakage of the insulation.

Install the appropriate position of the mixer, at least 10CM above the water surface. After the mixer cable is installed, it must be beyond the water surface. If water is added, it should be properly wrapped with waterproof tape and insulating tape at the joint and properly fixed. When the mixer is installed, the anchor bolts must be securely fastened. Can be installed with liquid level controller (recommended to use non-electrode type, such as mercury or steel ball type, let the mixer operate automatically, the operation and stop water level of the liquid level controller should be properly adjusted to avoid the mixer being lower than the continuous running water level for a long time operation.